In-Band Management; Management Via Telnet - Accton Technology ES4710BD User Manual

Current time is WED APR 20 09:37:52 2005
ES4710BD Series Switch Operating System,
Software Packet Version ES4704BD_2.2.10.0
Copyright (C) 2001-2004 by Accton Technology Corp.
http://www.edge-core.com
ES4710BD Switch (MPC8245-266M) processor
ES4710BD>
The user can now enter commands to manage the switch. For a detailed description of commands,
please refer to the following chapters.

4.1.2 In-band Management

In-band management refers to the management by logging into the switch using Telnet or
ECview. ECview is a network management software developed by Edge-Core. In-band management
enables management of the switch by devices attached to the switch. In the case when in-band
management fails due to switch configuration changes, out-of-band management can be used for
configuring and managing the switch.

4.1.2.1 Management via Telnet

To manage the switch with Telnet, the following conditions should be met:
1) Switch has an IP address configured
2) The host's IP address (Telnet client) and the switch's VLAN interface IP address are in the
same network segment.
3) If not 2), the Telnet client can connect to an IP address of the switch via other devices, such
as a router.
ES4710BD is a Layer 3 switch that can be configured with several IP addresses. The following
example assumes the shipment's default status of the switch, only VLAN1 exists in the system.
The following describes the steps for a Telnet client to connect to the switch's VLAN1
interface by Telnet.
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
82