Configuring Snmp - Accton Technology ES4710BD User Manual

Note: valid password length is 1 to 8 characters. After configuring the username and password, the
menu will return to the Web server configuration section.
Select "1" in the Web server configuration menu and press Enter, the following screen appears:
Enable switch web-server or no?(y/n) [y]:
The corresponding prompt in Chinese is:
是否使能交 机 Web 服 器?(y/n) [y]:
Type "n" and press Enter to disable Web service. Type "y" and press Enter, or just press Enter to
enable Web service. The Web server configuration menu will then appear.
Select "2" in the Web server configuration menu to return to the Setup main menu.

3.1.2.5 Configuring SNMP

Select "4" in the Setup main menu and press Enter to start configuring SNMP, the following will
appear:
Configure SNMP
[0]: Config SNMP-server read-write community string
[1]: Config SNMP-server read-only community string
[2]: Config traps-host and community string
[3]: Config SNMP-server status
[4]: Config SNMP traps status
[5]: Add SNMP NMS security IP address
[6]: Exit
Selection number:
The corresponding prompt in Chinese is:
配置 SNMP
[0]: 配置 SNMP
[1]: 配置 SNMP 只
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
写 体字符串
体字符串
75