Network Management Port Configuration Commands; Duplex - Accton Technology ES4710BD User Manual

Command
Global Mode
interface ethernet <num>
2. Configure the properties for the network management port
Command
Network Management Port Configuration
shutdown
no shutdown
speed {auto| force10| force100| }
duplex {auto| full| half}
loopback
no loopback
ip address <ip-address> <mask>
no ip address [<ip-address> <mask>]

7.2.3.2 Network Management Port Configuration Commands

7.2.3.2.1 duplex

Command: duplex {auto| full| half }
Function: Sets network management port duplex mode
Parameters: auto for auto-negotiation full-duplex mode; full for forced full-duplex mode; half
for forced half-duplex mode.
Command mode: Network management port configuration Mode
Default: The default duplex mode is set to auto-negotiation.
Usage Guide: According to IEEE 802.3, the auto-negotiation for port speed and duplex are linked.
If the duplex setting of the port is auto-negotiation, the port speed will be set to auto-negotiation
automatically; if the port duplex mode changes from auto-negotiation to forced full/half-duplex, the
port speed will also become forced mode, the forced speed will be the port speed before this
command.
It is strongly recommended for the users to set all port speed and duplex mode to auto-negotiation,
this can minimize protocol-related connection problems. If forced speed/duplex mode needs to be
set, the speed/duplex mode setting of both ends must be verified to be the same.
Example: Setting the network management port to forced full-duplex mode.
Switch(Config)#interface ethernet 0
Switch(Config-Ethernet0)#duplex full
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
Explanation
Enables/Disables network management port
Sets network management port speed
Sets network management port duplex mode
Enables/Disables loopback test function for
network management port
Configures or cancels the IP address for
network management port.
168
Explanation
Enters the network management
port configuration mode