Table of Contents
Advertisement
debugging function.
Command mode: Admin Mode
Default: GVRP debugging information is disabled by default.
Usage Guide: Use this command to enable GVRP debugging, GVRP packet processing information
can be displayed.
Example: Enabling GVRP debug.
Switch#debug gvrp
9.4.2 VLAN Troubleshooting Help
The GARP counter setting in for Trunk ports in both ends of Trunk link must be the same,
otherwise GVRP will not work properly.
It is recommended to avoid enabling GVRP and RSTP at the same time in ES4710BD. If GVRP is
to be enabled, RSTP function for the ports must be disabled first.
9.5 WEB MANAGEMENT
Click "Vlan configuration" to open the vlan allocation management list to manage the VLAN
configuration of the switch.
9.5.1 Vlan configuration
Click "Vlan configuration", "Vlan configuration" to open vlan allocation management list.
9.5.1.1
Create/remove Vlan
Click "Vlan configuration", "Vlan configuration", "Create/Remove VLAN" to open the adding/
deleting vlan management list of the switch .
9.5.1.1.1 VID allocation
Click "Vlan configuration", "Vlan configuration", "Create/Remove VLAN", "VID allocation" to
create and remove VLAN. Equals to CLI command 9.2.2.1:
Operation type: Add new VID create a new means to VLAN; Remove means to remove a
VLAN
VID: specified VLAN ID
Example: Select "Add new VID" and set up VID as 100 and click Apply button then a new VLAN
100 is created.
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
217
Advertisement
Table of Contents
Troubleshooting
