Table of Contents
Advertisement
20.2.2.4
dot1x eapor enable
Command: dot1x eapor enable
no dot1x eapor enable
Function: Enables the EAP relay authentication function in the switch; the "no dot1x eapor
enable" command sets EAP local end authentication.
Command mode: Global Mode
Default: EAP relay authentication is used by default.
Usage Guide: The switch and RADIUS may be connected via Ethernet or PPP. If an Ethernet
connection exists between the switch and RADIUS server, the switch needs to
authenticate the user by EAP relay (EAPoR authentication); if the switch connects to
the RADIUS server by PPP, the switch will use EAP local end authentication (CHAP
authentication). The switch should use different authentication methods according to
the connection between the switch and the authentication server.
Example: Setting EAP local end authentication for the switch.
Switch(Config)#no dot1x eapor enable
20.2.2.5
dot1x enable
Command: dot1x enable
no dot1x enable
Function: Enables the 802.1x function in the switch and ports: the "no dot1x enable" command
disables the 802.1x function.
Command mode: Global Mode and Interface Mode.
Default: 802.1x function is not enabled in global mode by default; if 802.1x is enabled under
Global Mode, 802.1x will not be enabled for the ports by default.
Usage Guide: The 802.1x authentication for the switch must be enabled first to enable 802.1x
authentication for the respective ports. If Spanning Tree or MAC binding is enabled
on the port, or the port is a Trunk port or member of port aggregation group, 802.1x
function cannot be enabled for that port unless such conditions are removed.
Example: Enabling the 802.1x function of the switch and enable 802.1x for port 1/12.
Switch(Config)#dot1x enable
Switch(Config)#interface ethernet 1/12
Switch(Config-Ethernet0/0/12)#dot1x enable
20.2.2.6
dot1x privateclient enable
Command: dot1x privateclient enable
no dot1x privateclient enable
Function: Enables the switch to force client software to use Edge-Core's proprietary 802.1x
authentication packet format; the "no dot1x privateclient enable" command disables
the function and allow the client software to use standard 802.1x authentication packet
format.
Command mode: Global Mode
Default: Proprietary authentication is not supported by the switch.
Usage Guide: To implement the Edge-Core overall solution, Edge-Core proprietary 802.1x
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
514
Advertisement
Table of Contents
Troubleshooting
