Table of Contents
Advertisement
19.5.2.2.6
ip dvmrp probe-interval
Command: ip dvmrp probe-interval <time_val>
no ip dvmrp probe-interval
Function: Sets the interval for sending DVMRP probe messages; the "no ip dvmrp probe
interval" command restores the default setting.
Parameters: <time_val> is the interval for sending DVMRP probe packets, ranging from 5 to 30
seconds..
Default: The default interval for sending DVMRP probe messages is 10 seconds.
Command mode: Global Mode
Usage Guide: The probe message enables DVMRP switches to locate each other and establish the
neighborhood, and to learn the capability of each other. DVMRP switches claim their
existence by sending probe message to their neighbors. If no probe message from a
neighbor is received in a specified period, that neighbor is considered to be lost. This
time must be no greater than the neighbor timeout time.
Example: Setting the interval for sending DVMRP probe messages to 20 seconds..
Switch (Config)#ip dvmrp probe-interval 20
19.5.2.2.7
ip dvmrp report-interval
Command: ip dvmrp report-interval <time_val>
no ip dvmrp report-interval
Function: Sets the interval for sending DVMRP report messages; the "no ip dvmrp
report-interval" command restores the default setting.
Parameters: <time_val> is the interval for sending DVMRP report packets, ranging from 10 to
2000 seconds.
Default: The default interval for sending DVMRP report messages is 60 seconds.
Command mode: Global Mode
Usage Guide: DVMRP route information is exchanged in the way similar to that in RIP, i.e., in the
report messages between DVMRP neighbors periodically. If no updating report
message for a route from the neighbor of the route is received in the specified
interval, then the route is considered to be invalid. This interval configured must be
no greater than the timeout interval for the route.
Example: Setting the interval for sending DVMRP route report messages to 100 seconds.
Switch (Config)#ip dvmrp report-interval 100
19.5.2.2.8
ip dvmrp route-timeout
Command: ip dvmrp route-timeout <time_val>
no ip dvmrp route-timeout
Function: Sets timeout interval for a DVMRP route; the "no ip dvmrp route-timeout" command
restores the default setting.
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
485
Advertisement
Table of Contents
Troubleshooting
