Show Interface; Port Troubleshooting Help; Web Management - Accton Technology ES4710BD User Manual

Default: Port statistics are not cleared by default.
Usage Guide: If no port is specified, then statistics of all ports will be cleared.
Example: Clearing the statistics for Ethernet port 1/1.
Switch#clear counters ethernet 1/1

7.4.1.2 show interface

Command: show interface [{ethernet <interface-number> | vlan <vlan-id> | port-channel
<port-channel-number> | <interface-name>}]
Function: Displays information about specified port.
Parameters: <interface-number> stands for the Ethernet port number; < vlan-id > stands for the
VLAN interface number; <port-channel-number> for trunk interface number; <interface-name>
for interface name, such as port-channel 1.
Command mode: Admin Mode
Default: No port information is displayed by default.
Usage Guide: For Ethernet ports, this command displays information about port speed, duplex
mode, traffic control on/off, broadcast storm control and statistics for packets sent/received; for
VLAN interfaces, this command displays MAC address, IP address and statistics for packets
sent/received; for trunk ports, this command displays port speed, duplex mode, traffic control on/off,
broadcast storm control and statistics for packets sent/received. Usage Guide: If no ports are
specified, then information for all ports will be displayed.
Example: Displaying information about port 4/1.
Switch#show interface ethernet 4/1

7.4.2 Port Troubleshooting Help

Here are some situations that frequently occurs in port configuration and the advised solutions:
Two connected fiber interfaces won't link up if one interface is set to auto-negotiation but
the other to forced speed/duplex. This is determined by IEEE 802.3.
The following combinations are not recommended: enabling traffic control as well as
setting multicast limiting for the same port; setting broadcast, multicast and unknown
destination unicast control as well as port bandwidth limiting for the same port. If such
combinations are set, the port throughput may fall below the expected performance.

7.5 WEB MANAGEMENT

Click "Port configuration" to open the port configuration management table. Users can proceed to
do port management, setup port speed, duplexes and so on.
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
175