Table of Contents
Advertisement
Switch#show running-config
5.2.4.7 show startup-config
Command: show startup-config
Function: Displays the switch parameter configurations written in the Flash memory at the current
operation, those are usually also the configuration files used for the next power-up.
Default: If the configuration parameters read from the Flash are the same as the default operating
parameter, nothing will be displayed.
Command mode: Admin Mode
Usage Guide: The show running-config command differs from show startup-config in that when
the user finishes a set of configurations, show running-config displays the added-on configurations
while show startup-config won't display any configurations. However, if write command is
executed to save the active configuration to the Flash memory, the displays of show running-config
and show startup-config will be the same.
5.2.4.8 show switchport interface
Command: show switchport interface [ethernet <interface-list>]
Function: Displays VLAN interface mode, LAN number, and Trunk port information for the
switch.
Parameters: <interface-list> is the port number or a port list, which can be for any port information
existing in the switch.
Command mode: Admin Mode
Example: Displays the VLAN information for interface ethernet 1/1.
Switch#show switchport interface ethernet 1/1
Ethernet1/1
Type :Universal
Mac addr num :-1
Mode :Access
Port VID :1
Trunk allowed Vlan :ALL
Displayed information
Ethernet1/1
Type
Mac addr num
Mode :Access
Port VID :1
Trunk allowed Vlan :ALL
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
Description
Corresponding Ethernet interface number
Current Interface Type
MAC address number can be learned by the current
interface
VLAN mode of the current Interface
VLAN number belong to the current Interface
VLAN allowed to be crossed by Trunk.
105
Advertisement
Table of Contents
Troubleshooting
