Table of Contents
Advertisement
authentication packets support must be enabled in the switch, otherwise many
application would not be available. For detailed information, please refer to the
introduction of Edge-Core Overall Solution, Standard 802.1x client would not be
authenticated if Edge-Core proprietary 802.1x authentication packet format is
enforced for client software by the switch.
Example: Enabling the switch to force client software to use Edge-Core proprietary 802.1x
authentication packet format.
Switch(Config)#dot1x privateclient enable
20.2.2.7
dot1x macfilter enable
Command: dot1x macfilter enable
no dot1x macfilter enable
Function: Enables the dot1x address filter function in the switch; the "no dot1x macfilter enable"
command disables the dot1x address filter function.
Command mode: Global Mode
Default: dot1x address filter is disabled by default.
Usage Guide: When dot1x address filter function is enabled, the switch will filter the authentication
user by the MAC address. Only the authentication request initialed by the users in
the dot1x address filter table will be accepted.
Example: Enabling dot1x address filter function for the switch.
Switch(Config)#dot1x macfilter enable
20.2.2.8
dot1x max-req
Command: dot1x max-req <count>
no dot1x max-req
Function: Sets the number of EAP request/MD5 frame to be sent before the switch re-initials
authentication on no supplicant response; the "no dot1x max-req" command restores
the default setting.
Parameters: < count> is the times to re-transfer EAP request/ MD5 frames, the valid range is 1 to
10.
Command mode: Global Mode
Default: The default maximum for retransmission is 2.
Usage Guide: The default value is recommended in setting the EAP request/ MD5 retransmission
times.
Example: Changing the maximum retransmission times for EAP request/ MD5 frames to 5 times.
Switch(Config)#dot1x max-req 5
20.2.2.9
dot1x max-user
Command: dot1x max-user <number>
no dot1x max-user
Function: Sets the maximum users allowed to connect to the port; the "no dot1x max-user"
command restores the default setting.
Parameters: < number> is the maximum users allowed, the valid range is 1 to 254.
Command mode: Port configuration Mode.
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
515
Advertisement
Table of Contents
Troubleshooting
