Table of Contents
Advertisement
specified period, that neighbor is considered to be lost. This time setting must be no
greater than the neighbor timeout time.
Example: Configuring PIM-SM HELLO interval on interface vlan1.
Switch (Config)#interface vlan 1
Switch(Config-If-Vlan1)#ip pim query-interval 20
19.4.2.2.4
ip pim bsr-candidate
Command: ip pim bsr-candidate <ifname> [hash-mask-length] [priority]
no ip pim bsr-candidate
Function: This command is a global candidate BSR configuration command. It is used to configure
information for PIM-SM candidate BSR and to contend for the BSR router with the
other candidate BSRs; the "no ip pim bsr-candidate" command cancels the BSR
configuration.
Parameters: ifname is the name of the specified interface; [hash-mask-length] is the mask length
of the specified hash algorithm used in RP boot selection, ranging from 0 to 32;
[priority] is the BSR priority of this candidate BSR, ranging from 0 to 255, if this
parameter is omitted, the priority of this candidate BSR will be defaulted to 0.
Default: The switch is not a BSR candidate router by default.
Command mode: Global Mode
Usage Guide: This command is a global candidate BSR configuration command. It is used to
configure information for PIM-SM candidate BSR and to contend for the BSR
router with the other candidate BSRs. The switch will be a BSR candidate router
only when this command is configured.
Example: Setting the interface vlan1 as the BSR message sending interface.
Switch (Config)# ip pim bsr-candidate vlan1 30 10
19.4.2.2.5
ip pim rp-candidate
Command: ip pim rp-candidate <ifname> [group-list access-list] [interval interval]
no ip pim rp-candidate [<ifname>]
Function: This command is a global candidate RP configuration command. It is used to configure
information for PIM-SM candidate RP and to contend for the RP router with the other
candidate RPs; the "no ip pim rp-candidate [<ifname>]" command cancels the RP
configuration.
Parameters: <ifname> is the name of specified interface; access-list is the number of group range
list can be used as the RP in the switch, ranging from 1 to 99, if this parameter is
omitted, the router can work as the RP for all multicast groups; interval is the interval
for the local candidate RP to send C-RP packets, ranging from 1 to 16383 seconds.
Default: The switch is not a BSR candidate router by default.
Command mode: Global Mode
Usage Guide: This command is a global candidate RP configuration command. It is used to
configure information for PIM-SM candidate RP and to contend for the RP router
with the other candidate RPs. The switch will be a RP candidate router only when
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
472
Advertisement
Table of Contents
Troubleshooting
