Ospf Configuration Commands - Accton Technology ES4710BD User Manual

(3) Configure other OSPF protocol parameters
a. Configure OSPF routing protocol priority
b. Configure cost for OSPF STUB area and default route
c. Configure OSPF virtual link
Command
OSPF protocol configuration mode
preference [ ase ] <preference >
no preference [ ase ]
stub cost <cost> area <area_id >
no stub area <area_id >
virtuallink neighborid
transitarea <area_id> [ hellointerval <time> ]
[ deadinterval <time> ] [ retransmit <time> ]
[ transitdelay <time> ]
no virtuallink
transitarea <area_id>
d. Configure the priority of the interface when electing designated layer 3 switch (DR).
Command
Interface Mode
ip ospf priority <priority>
no ip ospf priority
3. Disable OSPF protocol.
Command
Global Mode
no router ospf
18.4.2.2

OSPF Configuration Commands

default redistribute cost
default redistribute interval
default redistribute limit
default redistribute tag
default redistribute type
ip opsf authentication
ip ospf cost
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
<router_id>
neighborid <router_id>
Explanation
Sets the priority of the interface in "designated
layer 3 switch" election; the "no ip ospf priority"
command restores the default setting.
Explanation
Disables OSPF routing protocol
Explanation
Configures the priority of OSPF among
all the routing protocols, and the priority
for AS exterior routes introduced; the "no
preference [ ase ]" command restores the
default setting.
Sets an area to STUB area; the "no stub
area <area_id >" command cancels the
setting.
Creates and configures virtual link; the
"no virtuallink neighborid <router_id>
transitarea <area_id>" command deletes
a virtual link.
410