19.7.3.4 Set router as BSR candidate
Click Set router as BSR candidate for configure PIM-SM candidate BSR information ,for compete
with other candidate BSR for BSR router. This is the same as CLI command 19.4.2.2.4
Set router as BSR candidate - yes means configure the switch as PIM-SM domain
candidate BSR;no means cancel switch to configure as candidate BSR
Port - assign layer 3 interface VLAN ID(select from scroll bar menu)
Hash mask length - assigns hash mask length
Priority - assigns priority
Apply - runs according to configured parameter
Default - cancels switch to configure as candidate BSR
19.7.3.5 Set router as RP candidate
Click "Set router as RP candidate" to configure PIM-SM candidate RP information, to compete with
other candidate RPs for RP router. This is the same as CLI command 19.4.2.2.5
Set router as RP candidate - yes means configure switch as candidate PIM-SM RP;no
means cancel RP configuration
Port - assign layer 3 interface VLAN ID(select from scroll bar menu)
Group-List - assign access-list ID
Interval - assign sending candidate RP message interval
Apply - run according to configured parameter
Default - cancel RP configuration
19.7.4 DVMRP configuration
19.7.4.1 Enable DVMRP
In DVMRP protocol configuration mode, click "Enable DVMRP" to enable or disable DVMRP
protocol in specific interface. This is the sameas CLI command 19.5.2.2.2
Enable DVMRP - yes means enable DVMRP protocol; no means disable DVMRP
protocol
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
503