Rip Configuration Commands - Accton Technology ES4710BD User Manual

ip rip receive version {v1 | v2 | v12}
no ip rip receive version
[no] ip rip input
[no] ip rip output
4. Disable RIP
Command
Global Mode
no router rip
RIP (Routing Information Protocol) is a dynamic interior routing protocol based on distance
vector. It is widely used for its simple configurations. RIP exchanges routing information by UDP
packet advertisement, route update information is sent every 30 seconds. It uses hop number as the
standard for choosing a route, routes with less hops to the same destination network will be chosen
first. The maximum hop number allowed is 16, so RIP is suitable for autonomous systems with
relative small diameter. RIP configuration commands are mainly used in Global Mode, RIP
configuration mode, Interface Mode and Admin Mode.
18.3.2.2

RIP Configuration Commands

auto-summary
default-metric
ip rip authentication key-chain
ip rip authentication mode
ip rip metricin
ip rip metricout
ip rip input
ip rip output
ip rip receive version
ip rip send version
ip rip work
ip split horizon
redistribute
rip broadcast
rip checkzero
rip preference
router rip
timer basic
version
show ip protocols
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
Sets the version of RIP packets to receive on all
ports; the "no ip rip receive version" command
restores the default, i.e., receives both v1 and v2
packets,
Enables receiving RIP packets on the interface; the
"no ip rip input" command disables receiving
RIP packets on the interface
Enables sending RIP packets on the interface; the
"no ip rip output" command disables sending
RIP packets on the interface
Explanation
Disables RIP
389