Table of Contents
Advertisement
8.5.1.3.2 MAC Address Binding Troubleshooting Help
Enabling MAC address binding for ports may fail on some occasions. Here are some possible
causes and solutions:
If MAC address binding cannot be enabled for a port, make sure the port is not executing
Spanning tree, port aggregation and is not configured as a Trunk port. MAC address binding is
exclusive to such configurations. If MAC address binding is to be enabled, the
above-mentioned functions must be disabled first.
If a secure address is set as a static address and deleted, than that secure address will be
unusable even though it no longer exists. For this reason, it is recommended to avoid static
address for ports enabling MAC address binding.
8.6 WEB MANAGEMENT
Click "MAC address table configuration" to open MAC address configuration management list.
Users can proceed to manage, set security port, add and delete MAC addresses, and so on.
8.6.1 Mac address table configuration
Click "MAC address table configuration", to open MAC address list configuration management list
to manage add delete MAC addresses.
8.6.1.1
Unicast address configuration
Click "MAC address table configuration", "MAC address table configuration", "unicast address
configuration", "unicast address configuration" to add MAC addresses. Equals to CLI command
8.2.2：
MAC address: Specifies a MAC address
VID: The VLAN number of the MAC address
Configuration type: static means static address; blackhole means filter address
Port list: MAC address's port
Address aging-time: Aging time of dynamic MAC addresses
Operation type: adds/deletes a MAC address
Example:
Set up MAC address as 00-11-11-11-11-11, select VID as 1, configuration type as static; port list as
Ethernet 1/1 and address aging-time as 400 seconds. Select operation type as add mac address and
click Apply button. Then the set up will be applied to port 1/1.
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
195
Advertisement
Table of Contents
Troubleshooting
