Show Ip Rip - Accton Technology ES4710BD User Manual

Usage Guide: The user can decide whether the routing protocols configured are correct and perform
routing troubleshooting according to the output of this command.
Example:
Switch#sh ip protocols
RIP information
rip is turning on
default metrict 16
neighbour is:NULL
preference is 100
rip version information is:
interface send version
vlan2
vlan3
vlan4
Displayed information
RIP is turning on
default metric
neighbour is:
Preference
rip version information

18.3.2.2.21 show ip rip

Command: show ip rip
Function: Displays the current running status and configuration information for RIP.
Command mode: Admin Mode
Usage Guide: The user can check the default metric of RIP route. The specified sending destination
address and metric value according to the output of this command will be shown.
Example:
Switch#sh ip rip
RIP information
rip is turning on
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
receive version
V2BC
V2BC
V2BC
V12
V12
V12
Explanation
The running routing protocol is RIP
RIP protocol default metric value
The neighbor layer 3 switch connecting to this
RIP switch
RIP routing priority
Displays the version information for RIP,
including the RIP version of sending (V1 for
RIP-I, V2 for RIP-II), RIP sending method (BC
for broadcast, MC for multicast), RIP version
of receiving (V1 for RIP-I, V2 for RIP-II, V12
for both RIP-I and RIP-II)
397