Mac Address Binding Configuration Commands; Switchport Port-Security; Switchport Port-Security Convert; Switchport Port-Security Lock - Accton Technology ES4710BD User Manual

8.5.1.2.2 MAC Address Binding Configuration Commands

8.5.1.2.2.1 switchport port-security

Command: switchport port-security
no switchport port-security
Function: Enables the MAC address binding function for the port: the "no switchport
port-security" command disables the MAC address binding function for the port.
Command mode: Interface Mode
Default: MAC address binding is not enabled by default.
Usage Guide: The MAC address binding function, Spanning Tree and Port Aggregation functions
are mutually exclusive. Therefore, if the MAC binding function for a port is to be enabled, the
Spanning Tree and Port Aggregation functions must be disabled, and the port enabling MAC address
binding must not be a Trunk port.
Example: Enabling the MAC address binding function for port 1
Switch(Config)#interface Ethernet 1/1
Switch(Config-Ethernet1/1)#switchport port-security

8.5.1.2.2.2 switchport port-security convert

Command: switchport port-security convert
Function: Converts dynamic secure MAC addresses learned by the port to static secure MAC
addresses, and disables the MAC address learning function for the port.
Command mode: Interface Mode
Usage Guide: The port dynamic MAC convert command can only be executed after the secure port
is locked. After this command has been executed, dynamic secure MAC addresses learned by the
port will be converted to static secure MAC addresses. The command does not reserve
configuration.
Example: Converting MAC addresses in port 1 to static secure MAC addresses.
Switch(Config)#interface Ethernet 1/1
Switch(Config-Ethernet1/1)#switchport port-security convert

8.5.1.2.2.3 switchport port-security lock

Command: switchport port-security lock
no switchport port-security lock
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
189