Table of Contents
Advertisement
19.7 WEB MANAGEMENT
Click "root page" left content column "Multicast protocol configuration" to enter into multicast
protocol configuration root node and make configuration for multicast protocol.
Click Multicast common configuration to enter into multicast protocol public monitor mode
Click PIM-DM configuration to enter into PIM-DM protocol configuration mode
Click PIM-SM configuration to enter into PIM-SM protocol configuration mode
Click DVMRP configuration to enter into DVMRP protocol configuration mode
Click IGMP configuration to enter into IGMP protocol configuration mode
Click Inspect and debug to enter into multicast protocol debug monitor mode
19.7.1 Multicast public monitor command
Example: In multicast protocol public monitor mode, click Show ip mroute to display IP multicast
message forward item. This is the same as CLI command 19.2.1.1.1. No additional parameter
configuration necessary. For the detailed information, please refer to 19.2.1.1.1：
19.7.2 PIM-DM configuration
19.7.2.1 Enable PIM-DM
In PIM-DM protocol configuration mode, click "Enable PIM-DM" to enable or disable PIM-DM
protocol in layer 3 interface. This is the same as CLI command 19.3.2.3.
Enable PIM-DM: yes means enable PIM-DM protocol；no means disable PIM-DM
protocol
Vlan Port: assigns layer 3 interface (select from scroll bar menu）
Apply: runs according to configured parameter
Default: disables assign layer 3 interface PIM-DM protocol
19.7.2.2 PIM-DM parameter configuration
Click "PIM-DM parameter configuration" to configure the PIM-DM running parameters for a
specific layer 3 interface. This is the same as CLI command 19.3.2.4.
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
501
Advertisement
Table of Contents
Troubleshooting
