Table of Contents
Advertisement
same as CLI command 19.5.2.2.3
Interval of sending probe packet － Configures the interval of sending probe packet.
This is the same as CLI command 19.5.2.2.6
Interval of sending report packet － Configures the interval of sending report packet.
This is the same as CLI command 19.5.2.2.7
DVMRP route timeout －configures DVMRP route timeout. This is the same as CLI
command 19.5.2.2.8
Apply － runs according to configured parameter
Default － restores the global configuration parameter to default (includes sending graft,
probe, report message interval, dvmrp route timeout）
Note：Because the page correspondence 4 PCS CLI command，it will appear error parameter
message when only configure one or many parameter, it's not affected.
19.7.4.5 DVMRP tunnel configuration
Click "DVMRP tunnel configuration to create", repeal the tunnel which to neighbor DVMRP
tunnel . This is the same as CLI command 19.5.2.2.9
Neighbor ip address － remote neighbor IP address
Metric － tunnel interface metric
Vlan Port － assigns layer 3 interface（select from scroll bar menu）
Apply － creates DVMRP tunnel to specific neighbor
Delete tunnel － removes DVMRP tunnel to specific neighbor
19.7.5 IGMP configuration
19.7.5.1 IGMP additive parameter configuration
In "IGMP protocol configuration mode", click "IGMP additive parameter configuration" to
configure IGMP protocol interface parameters. This is the same as 6 PCS CLI command 19.6.2.2.1,
19.6.2.2.2, 19.6.2.2.3, 19.6.2.2.4, 19.6.2.2.5, 19.6.2.2.6
Set Acl for IGMP group － Configures interface filter qualifications to IGMP group.
This is the same as CLI command 19.6.2.2.1
Add interface to IGMP group － Configures interface to join some IGMP group. This is
the same as CLI command 19.6.2.2.2
Add IGMP static group to VLAN － Configures interface join some IGMP static group.
This is the same as CLI command 19.6.2.2.6
IGMP query interval － Configures IGMP query interval. This is the same as CLI
command 19.6.2.2.3
Max-response IGMP request time － Configures max-response IGMP request time. This
is the same as CLI command 19.6.2.2.4
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
505
Advertisement
Table of Contents
Troubleshooting
