Add/Remove Aggregate Policy; Apply Aggregate Policy - Accton Technology ES4710BD User Manual

16.5.3.4 Add/Remove aggregate policy

Click Add/Remove aggregate policer to entry configure page. It is equivalent to CLI command
16.2.2.8.
Terms are described as following:
Aggregate policer name
Rate－average baud rate for classified bandwidth, K bit/s per unit.
Burst－burst rate for classified bandwidth, K byte per unit.
Exceed-action－The action for once the data rate exceeds the rate limited, includes drop and
policied-dscp-transmit, the latter is by a mapping function between given DSCP and
corresponding policy and mark the DSCP into the packet.
To create the aggregate-policer, named as agg1, the definition of aggregate-policer is based on
the baud rate 20M Kbps, the burst rate 2M Kbyte. All packets will be dropped whenever over
the assigned running rate. After setting all value, then click Add.

16.5.3.5 Apply aggregate policy

Click "Apply aggregate policer" to enter the configuration page. Equivalent to CLI command
16.2.2.9.
Terms are described as following:
Aggregate policer name
Policy-map name
Class-map name
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
360