Ip Rip Authentication Mode; Ip Rip Metricin - Accton Technology ES4710BD User Manual

Command: ip rip authentication key-chain <name-of-chain>
no ip rip authentication key-chain
Function: Specifies the key to use for RIP authentication; the "no ip rip authentication
key-chain" command cancels the RIP authentication.
Parameters: <name-of-chain> is a string, up to 16 characters are allowed.
Default: RIP authentication is disabled by default.
Command mode: Interface Mode
Usage Guide: Instead of deleting the RIP authentication key, the "no ip rip authentication
key-chain" command cancels the RIP authentication.
Related command: ip rip authentication
18.3.2.2.4

ip rip authentication mode

Command: ip rip authentiaction mode {text|md5 type {cisco|usual}}
no ip rip authentication mode
Function: Sets the authentication method; the "no ip rip authentication mode" command restores
the default plain text authentication method.
Parameters: "text" for text authentication; "md5" for MD5 authentication. There two MD5
authentication methods, Cisco MD5 and conventional MD5.
Default: The default setting is text authentication.
Command mode: Interface Mode
Usage Guide: RIP-I does not support authentication, RIP-II supports 2 authentication methods: text
authentication (Simple authentication) and packets authentication (MD5 authentication). There 2
packets types used in MD5 authentication, one format complies with RFC1723 (RIP Version 2
Carrying Additional Information) and the other format conforms to RFC2082 (RIP-II MD5
Authentication).
Example: Setting Cisco MD5 authentication on interface vlan1, the authentication key is
"edgecore".
Switch(Config-If-Vlan1)#ip rip authentication mode md5 type cisco
Switch(Config-If-Vlan1)#ip rip authentication key-chain edgecore
Related command: ip rip authentication key-chain
18.3.2.2.5

ip rip metricin

Command: ip rip metricin <value>
no ip rip metricin
Function: Sets the additional route metric receiving RIP packets on the interface; the "no ip rip
metricin" command restores the default setting.
Parameters: < value> is the additional route metric, ranging from 1 to 15.
Default: The default additional route metric used for RIP to receive packets is 1.
Command mode: Interface Mode
Related command: ip rip metricout
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
391