Default Redistribute Cost - Accton Technology ES4710BD User Manual

ip opsf dead-interval
ip ospf enable area
ip ospf hello-interval
ip ospf passive-interface
ip ospf priority
ip ospf retransmit-interval
ip ospf transmit-delay
network
preference
redistribute ospfase
router id
router ospf
stub cost
virtuallink neighborid
show ip ospf
show ip ospfase
show ip ospf cumulative
show ip ospf database
show ip ospf interface
show ip ospf neighbor
show ip ospf routing
show ip ospf virtual-links
show ip protocols
debug ip ospf event
debug ip ospf lsa
debug ip ospf packet
debug ip ospf spf
18.4.2.2.1

default redistribute cost

Command: default redistribute cost <cost>
no default redistribute cost
Function: Sets the default cost for introducing exterior routes into OSPF; the "no default
redistribute cost" command restores the default setting.
Parameters: < cost> is the route cost, ranging from 1 to 65535.
Default: The default introducing cost is 1.
Command Mode: OSPF protocol configuration mode
Usage Guide: When OSPF routing protocol introduce the routes discovered by the other routing
protocols, those routes are regarded as exterior autonomous system routing information.
Introduction of exterior routing information requires some external parameter such as default cost
and default tag for the routes. This command allows the user to set reasonable default cost for
introducing exterior routes according to specific conditions
Example: Setting the default cost for OSPF to introduce exterior routes to 20.
Switch(Config-Router-Ospf)#default redistribute cost 20
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
411