Accton Technology ES4710BD User Manual page 444

area id
router id
router ip addr
state
priority
DR
BDR
last hello
last exch
（8）show ip ospf routing
The "show ip ospf routing" command can be used to display information about the OSPF route
table.
For example, displayed information can be:
Switch#show ip ospf routing
AS internal routes：
Destination Area
11.11.1.0 1
11.11.4.0 0
11.11.2.0 1
11.11.3.0 1
AS external routes：
Destination Cost
Displayed information
AS internal routes
AS external routes
Destination
Area
Cost
Dest Type
Next Hop
ADV rtr
（9）show ip ospf virtual-links
The "show ip ospf virtual-links" command can be used to display information about the OSPF
virtual link.
For example, displayed information can be:
Switch#show ip ospf virtual-links
no virtual-link
（10）show ip protocols
"show ip protocols" command can be used to display the information of the routing protocols
running in the switch.
For example, displayed information can be:
Switch#sh ip protocols
OSPF is running.
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
The id of the area for the interface
The ID of the neighbor layer 3 switch
IP address of the neighboring layer 3 switch
Link-state status
Priority
ID of the designated layer 3 switch
ID of the backup designated layer 3 switch
The last HELLO packet
The last packet exchanged
Cost Dest Type Next Hop
1 0 11.11.1.1
1 0 11.11.4.1
2 0 11.11.1.2
11 0 11.11.1.3
Dest Type Next Hop
Explanation
Autonomous system interior route
Autonomous system exterior route
Destination network segment
Area number
Cost value
Route Type
Next hop
Advertise the interface address of the layer 3 switch.
443
ADV rtr
14.14.14.1
11.11.4.2
11.11.2.1
14.14.14.1
ADV rtr