Table of Contents
Advertisement
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
Parameters: <ip-address> is the IP address in decimal format; <mask> is the subnet mask in
decimal format; [secondary] indicates the IP configured is a secondary IP address.
Command mode: VLAN Interface Mode
Default: No IP address is configured by default.
Usage Guide: This command configures the IP address for VLAN interface manually. If the
optional parameter secondary is not present, the IP address will be the primary IP of the VLAN
interface, otherwise, the IP address configured will be the secondary IP address for the VLAN
interface. A VLAN interface can have one primary IP address but multiple secondary IP addresses.
Both primary IP address and secondary IP addresses can be used for SNMP/Web/Telnet
management. In addition, ES4710BD allows IP addresses to be obtained through BootP/DHCP.
Example: Setting the IP address of VLAN1 interface to 192.168.1.10/24.
Switch(Config-If-Vlan1)#ip address 192.168.1.10 255.255.255.0
7.2.2.2.3 shutdown
Command: shutdown
no shutdown
Function: Shuts down the specified VLAN Interface; the "no shutdown" command opens the
VLAN interface.
Command mode: VLAN Interface Mode
Default: VLAN Interface is enabled by default.
Usage Guide: When VLAN interface is shutdown, no data frames will be sent by the VLAN
interface. If the VLAN interface needs to obtain IP address via BootP/DHCP protocol, it must be
enabled.
Example: Enabling VLAN1 interface of the switch.
Switch(Config-If-Vlan1)#no shutdown
7.2.3 Network Management Port Configuration
7.2.3.1 Network Management Port Configuration Task Sequence
1. Enter the network management port configuration mode
2. Configure the properties for the network management ports
（1） Enable/Disable ports
（2） Configure port speed
（3） Configure port duplex mode
（4） Enable/Disable port loopback function
（5） Configuring port IP Address
1. Enter the network management port configuration mode
167
Advertisement
Table of Contents
Troubleshooting
