Dhcp Debugging; Delete Binding Log - Accton Technology ES4710BD User Manual

Click "DHCP configuration", "DHCP relay configuration", "DHCP relay configuration" to
configure the switch's DHCP relay function:
DHCP forward UDP configuration configures DHCP relay to forward broadcast messages to a UDP
port. Same as CLI command 14.3.2.1:
Port - UDP port
Example: Configure Port as 69, and then click Add button to apply this configuration to switch.
DHCP help-address configuration assigns a destination address to where DHCP relay forwards UDP
messages. Same as CLI command 14.3.2.2:
IP address – server address
L3 Interface – Layer 3 port
Example: Configure IP address as 192.168.1.5, choose L3 Interface as Vlan1 Click Add button, to
apply this configuration to switch.
When layer 3 switch is working as DHCP relay, to configure the relay forwarding policy as
non-forwarding DHCP messages, click the Apply button. This will close the switch's DHCP
forwarding function. Click the Reset button to enable the switch's DHCP forwarding function. The
Default button restores the switch to forwarding DHCP in default mode.

14.6.4 DHCP debugging

Click "DHCP configuration", "DHCP debugging", to enable the switch DHCP debugging function
list to display switch DHCP configuration and debugging information.

14.6.4.1 Delete binding log

Click "DHCP configuration", "DHCP debugging", "Delete binding log" to remove some specific IP
address, the hardware address binding log or all IP addresses with relevant hardware address
binding logs.
Example: Choose Delete all binding log as Yes then click Apply button to remove all IP addresses
and hardware address binding records.
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
324