Table of Contents
Advertisement
command disables this debug function.
Command mode: Admin Mode
Default: IGMP Snooping debug is disabled by default.
Usage Guide: Use this command to enable IGMP Snooping debug, IGMP packet processing
information can be displayed.
Example: Enabling IGMP Snooping debug.
Switch# debug ip igmp snooping
11.4.2 IGMP Snooping Troubleshooting Help
IGMP Snooping function cannot be used with IGMP Query, Snooping is not available when
Query is enabled. The user must make sure which, IGMP Snooping or IGMP Query, is to be
enabled.
When IGMP Snooping is used, M-Router port must be specified in the corresponding VLAN,
or the switch cannot perform IGMP Snooping properly.
11.5 WEB MANAGEMENT
Click on the IGMP Snooping configuration, the IGMP Snooping configuration node and the IGMP
Snooping static multicast configuration node will be expanded. The IGMP Snooping configuration
screen is used for the configuration and display of the IGMP snooping & query. While the IGMP
Snooping static multicast configuration page is used for configuring the static address and
displaying all the IGMP snooping and every setting for VLAN.
11.5.1 Turning on the IGMP snooping function
Before we proceed with the configuration of IGMP Snooping configuration screen, the IGMP
snooping function must be enabled on first. The procedure is as follows:
Click "the switch basic configuration" expand the configuration tree
Click on "Switch on-off configuration" to turn on the switch configuration page
Under the IGMP snooping attribute choose open and then click on the Apply button. This
is equivalent to the CLI command 11.2.2.1
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
262
Advertisement
Table of Contents
Troubleshooting
