Front Panel - Reset Button; Front Panel - Swap Button; Em4700Bd-12Gt-Rj45; Front Panel - Accton Technology ES4710BD User Manual

Property
Connector
Connector type
1.4.2.1.5 Front Panel – Reset Button
EM4710BD-AGENT provides a RESET button for resetting the board.
1.4.2.1.6 Front Panel – SWAP Button
The EM4710BD-AGENT provides a SWAP button for hot swapping the module during operation.
Before removing the modules, users should press SWAP button first. The module will then prepare
for hot-swap and the system operation indicator (RUN) will turn yellow and blink at 8 Hz. When the
RUN indicator is off, the cards are powered off and can be removed.

1.4.2.2 EM4700BD-12GT-RJ45

12 copper Gb ports line card (EM4700BD-12GT-RJ45): supports 12 1000Base-T copper ports for
layer 2 and layer 3 switching and routing.
1.4.2.2.1

Front Panel

The EM4700BD-12GT-RJ45 provides 12 RJ45 ports (10/100/1000Mbps adaptive).
The Front Panel view is shown below:
1.4.2.2.2

Front Panel - Indicator

The following table describes the EM4700BD-12GT-RJ45's front panel indicators:
Table 1.4 EM4700BD-12GT-RJ45 indicator descriptions
Panel
LED
Symbol
Power
PWR
Indicator
Operation RUN
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
RJ-45 (Receptacle)
10/100Mbps auto sensing
Cat 5 UTP: 300 m
Fig 1-4 EM4700BD-12GT-RJ45 Front Panel view
Status
On (green)
Off
On (Green, blinks at 1 Hz)
Specification
Card powered
Card powered off
Card operating normally
41
Description