Table of Contents
Advertisement
Parameters: <string> is the community string set; ro|rw is the specified access mode to MIB, ro
for read-only and rw for read-write.
Usage Guide: Up to 4 community strings are supported by the switch.
Example: Adding a community string named "private" with read-write permission.
Switch(Config)#snmp-server community rw private
Add a community string named "public" with read-only permission.
Switch(Config)#snmp-server community ro public
Modify the read-write community string named "private" to read-only.
Switch(Config)#snmp-server community ro private
Delete community string "private".
Switch(Config)#no snmp-server community private
5.4.4.2.3 snmp-server enable
Command: snmp-server enable
no snmp-server enable
Function: Enables the SNMP agent server function in the switch: the "no snmp-server enable"
command disables the SNMP agent server function.
Command mode: Global Mode
Default: SNMP agent server function is disabled by default.
Usage Guide: To enable configuration and management via network administrative software, this
command must be executed to enable the SNMP agent server function for the switch.
Example: Enabling SNMP Agent server function for the switch.
Switch(Config)#snmp-server enable
5.4.4.2.4
snmp-server enable traps
Command: snmp-server enable traps
no snmp-server enable traps
Function: Sets to enable the switch to send Trap message; the "no snmp-server enable traps"
command disables Trap messages.
Command mode: Global Mode
Default: Trap message is disabled by default. .
Usage Guide: When Trap message is enabled, if Down/Up in device ports or of system occurs, the
device will send Trap messages to NMS that receives Trap messages.
Example:
Enable sending of Trap messages.
Switch(Config)#snmp-server enable traps
Disable sending of Trap messages
Switch(Config)#no snmp-server enable trap
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
115
Advertisement
Table of Contents
Troubleshooting
