Accton Technology ES4710BD User Manual page 409

(3) Configure other OSPF protocol parameters
a. Configure OSPF routing protocol priority
b. Configure cost for OSPF STUB area and default route
c. Configure OSPF virtual link
d. Configure the priority of the interface when electing designated layer 3 switch (DR).
3. Disable OSPF protocol.
1. Enable OSPF protocol
Basic configuration of OSPF routing protocol on ES4710BD series switches is quite simple,
usually only enabling OSPF and configuration of the OSPF area for the interface are required. The
OSPF protocol parameters can use the default settings. If OSPF protocol parameters need to be
modified, please refer to "2. Configure OSPF sub-parameters".
Command
Global Mode
[no] router ospf
router id <router_id>
no router id
OSPF protocol configuration mode
[no] network <network> <mask> area
<area_id> [ advertise | notadvertise ]
Interface Mode
ip ospf enable area <area_id>
no ip ospf enable area
2. Configure OSPF sub-parameters
(1) Configure OSPF packet sending mechanism parameters
a. Configure OSPF packet verification
b. Set the OSPF interface to receive only
c. Configure the cost for sending packets from the interface
Command
Interface Mode
ip ospf authentication { simple
<auth_key>| md5
<key_id>}
no ip ospf authentication
[no] ip ospf passive-interface
ip ospf cost <cost >
no ip ospf cost
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
Explanation
Enables OSPF protocol; the "no router ospf"
command disables OSPF protocol (required)
Configures the ID number for the layer 3 switch
running OSPF; the "no router id" command
cancels the ID number. The IP address of an
interface is selected to be the layer 3 switch ID.
(optional)
Defines several segments in an area to a network
scope; the "no network <network> <mask> area
<area_id> [ advertise | notadvertise ]" command
cancels the network scope. (optional)
Sets an area for the specified interface; the "no ip
ospf enable area" command cancels the setting.
(required)
Explanation
Configures the authentication method and key
<auth_key> required by the interface to accept OSPF packets;
the "no ip ospf authentication" command
restores the default setting.
Sets the interface to receive only, the "no ip ospf
passive-interface" command cancels the setting.
Sets the cost for running OSPF on the interface;
the "no ip ospf cost" command restores the
default setting.
408