Interface Port-Channel - Accton Technology ES4710BD User Manual

Command: port-group <port-group-number> mode {active|passive|on}
no port-group <port-group-number>
Function: Adds a physical port to port channel, the "no port-group <port-group-number>"
removes specified port from the port channel.
Parameters: <port-group-number> is the group number of port channel, from 1 to 8; active
enables LACP on the port and sets it in Active mode; passive enables LACP on the
port and sets it in Passive mode; on forces the port to join a port channel without
enabling LACP.
Command mode: Interface Mode
Default: Switch ports do not belong to a port channel by default; LACP not enabled by default.
Usage Guide: If the specified port group does not exist, a group will be created first to add the ports.
All ports in a port group must be added in the same mode, i.e., all ports use the
mode used by the first port added. Adding a port in "on" mode is a "forced" action,
which means the local end switch port aggregation does not rely on the information
of the other end, port aggregation will succeed as long as there are 2 or more ports in
the group and all ports have consistent VLAN information. Adding a port in "active"
or "passive" mode enables LACP. Ports of at least one end must be added in
"active" mode, if ports of both ends are added in "passive" mode, the ports will
never aggregate.
Example: Under the Port Mode of Ethernet1/1, add current port to "port-group 1" in "active" mode.
Switch(C onfig-Ethernet1/1)#port-group 1 mode active
13.2.2.3

interface port-channel

Command: interface port-channel <port-channel-number>
Function: Enters the port channel configuration mode
Command mode: Global Mode
Default:
Usage Guide: On entering aggregated port mode, configuration to GVRP or spanning tree modules
will apply to aggregated ports; if the aggregated port does not exist (i.e., ports have
not been aggregated), an error message will be displayed and configuration will be
saved and will be restored until the ports are aggregated. Note such restoration will
be performed only once, if an aggregated group is ungrouped and aggregated again,
the initial user configuration will not be restored. If it is configuration for modules,
such as shutdown or speed configuration, then the configuration to current port will
apply to all member ports in the corresponding port group.
Example: Entering configuration mode for port-channel 1.
Switch(C onfig)#interface port-channel 1
Switch(C onfig-If-Port-Channel1)#
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
287