Table of Contents
Advertisement
17.1.2.2
Layer 3 Interface Configuration Commands
17.1.2.2.1
interface vlan
Command: interface vlan <vlan-id>
no interface vlan <vlan-id>
Function: Creates a VLAN interface (a Layer 3 interface); the "no interface vlan <vlan-id>"
command deletes the Layer 3 interface specified.
Parameters: <vlan-id> is the VLAN ID of the established VLAN.
Default: No Layer 3 interface is configured upon switch shipment.
Command mode: Global Mode
Usage Guide: When crating a VLAN interface (Layer 3 interface), VLANs should be configured
first, for details, see the VLAN chapters. When VLAN interface (Layer 3 interface)
is created with this command, the VLAN interface (Layer 3 interface) configuration
mode will be entered. After the creation of the VLAN interface (Layer 3 interface),
interface vlan command can still be used to enter Layer 3 interface mode.
Example: Creating a VLAN interface (layer 3 interface).
Switch (Config)#interface vlan 1
17.2 IP Forwarding
17.2.1 Introduction to IP Forwarding
Gateway devices can forward IP packets from one subnet to another; such forwarding uses routes to
find a path. IP forwarding of ES4710BD is done with the participation of hardware and so wire
speed forwarding can be achieved. In addition, flexible management is provided to adjust and
monitor forwarding. ES4710BD supports aggregation algorithm enabling/disabling optimization to
adjust segment route generation in the switch chip and view statistics for IP forwarding and
hardware forwarding chip status.
17.2.2 IP Route Aggregation Configuration
17.2.2.1
IP Route Aggregation Configuration Task
1. Set whether IP route aggregation algorithm with/without optimization should be used.
Command
ip fib optimize
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
<vlan-id>" command deletes the VLAN
interface (Layer 3 interface) created in the
switch.
Explanation
Enables the switch to use optimized IP route
369
Advertisement
Table of Contents
Troubleshooting
