Table of Contents
Advertisement
Default: Debugging information is disabled by default.
Command mode: Admin Mode
Example:
Switch# debug vrrp
VRRP SEND[Hello]: Advertisement sent for vrid=[10], virtual-ip=[10.1.10.1]
VRRP SEND[Hello]: Advertisement sent for vrid=[10], virtual-ip=[10.1.10.1]
VRRP SEND[Hello]: Advertisement sent for vrid=[10], virtual-ip=[10.1.10.1]
VRRP SEND[Hello]: Advertisement sent for vrid=[10], virtual-ip=[10.1.10.1]
21.3.2 VRRP Troubleshooting Help
In configuring and using VRRP protocol, the VRRP protocol may fail to run properly due to
reasons such as physical connection failure or wrong configurations. The user should ensure the
following:
Good condition of the physical connection.
All interface and link protocols are in the UP state (use "show interface" command).
Ensure VRRP is enabled on the interface.
Verify the authentication mode of different routers (or L3 Ethernet switches) in the same
standby cluster are the same.
Verify the timer time of different routers (or L3 Ethernet switches) in the same standby
cluster are the same.
Verify the dummy IP address is in the same network segment of the interface's actual IP
address.
If VRRP problems persist after the above-mentioned procedures, please run debug
gingcommands like "debug vrrp", and copy the DEBUG information in 3 minutes and
send the information to Edge-Core technical service center.
21.4 WEB MANAGEMENT
Click "VRRP control" to enter VRRP control configuration mode to manage VRRP features for the
switch.
21.4.1 Create VRRP Number
Click "VRRP control" to enter "Create VRRP Number".
Example: Enter 1 for virtual router number and click Apply to create a virtual router with VRRP
number 1. Click Remove to remove Virtual Router 1.
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
543
Advertisement
Table of Contents
Troubleshooting
