Rip Troubleshooting Help; Monitor And Debug Commands - Accton Technology ES4710BD User Manual

SwitchC#config
SwitchC(Config)# interface vlan 2
SwitchC(Config-If-vlan2)# ip address 20.1.1.2 255.255.255.0
SwitchC (c config-If-vlan2)#exit
！Enable RIP
SwitchC(Config)#router rip
SwitchC(Config-router-rip)#exit
！Enable vlan2 to send/receive RIP packets
SwitchC(Config)#interface vlan 2
SwitchC (Config-If-vlan2)#ip rip work
SwitchC (Config-If-vlan2)exit
SwitchC(Config)#exit
SwitchC#

18.3.4 RIP Troubleshooting Help

1. Monitor and Debug Commands

2. RIP Troubleshooting Help
18.3.4.1 Monitor and Debug Commands
Command
Admin Mode
show ip rip
show ip route
show ip protocols
[no] debug ip rip packet
[no] debug ip rip recv
[no] debug ip rip send
（1）show ip rip
Displayed information:
RIP information:
Automatic network summarization is not in effect.
default metric for redistribute is :16
neigbour is :NULL
preference is :100
Explanation to displayed information:
Displayed information
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
Explanation
Displays the
configuration information for RIP. The user can
decide whether the configurations are correct or
not and perform RIP troubleshooting according to
the output of this command.
Displays route table information, RIP routing
information can be checked.
Displays protocol information
Displays all RIP packets received and sent.
Displays all RIP packets received
Displays all RIP packets sent.
Explanation
402
current running status and