Table of Contents
Advertisement
18.4.2.2.2
default redistribute interval
Command: default redistribute interval <time>
no default redistribute interval
Function: Sets the interval for introducing external routes; the "no default redistribute interval"
command restores the default setting.
Parameters: <time> is the interval for introducing exterior routes in seconds; the valid range is 1 to
65535 seconds.
Default: The default interval in OSPF for introducing exterior routes is 1 second.
Command Mode: OSPF protocol configuration mode
Usage Guide: OSPF introduces exterior routing information regularly and advertise the information
throughout the autonomous system. This command is used to modify the interval for introducing
exterior routing information.
Example: Setting the interval in OSPF for introducing exterior routes to 3 seconds.
Switch(Config-Router-Ospf)#default redistribute interval 3
18.4.2.2.3
default redistribute limit
Command: default redistribute limit <routes>
no default redistribute limit
Function: Sets the maximum exterior routes allowed in one route introduction; the "no default
redistribute limit" command restores the default setting.
Parameters: < value> is the maximum number of routes allowed in one route introduction, ranging
from 1 to 65535.
Default: The default exterior route allowed to be introduced in OSPF is 100.
Command Mode: OSPF protocol configuration mode
Usage Guide: OSPF introduces exterior routing information regularly and advertise the information
throughout the autonomous system. This command mandates the maximum exterior routes allowed
in one route introduction.
Example: Setting the maximum exterior routes allowed in one route introduction to 110.
Switch(Config-Router-Ospf)#default redistribute limit 110
18.4.2.2.4
default redistribute tag
Command: default redistribute tag <tag>
no default redistribute tag
Function: Sets the tag value for introducing exterior routes; the "no default redistribute tag"
command restores the default setting.
Parameters: < tag> is the tag value, ranging from 0 to 4294967295.
Default: The default tag value is 0.
Command Mode: OSPF protocol configuration mode
Usage Guide: When OSPF routing protocol introduces routes discovered by the other routing
protocols, those routes are regards as the exterior autonomous system routing information.
Introduction of exterior routing information requires external parameters such as default cost and
default tag for the routes. This command provides the user with information about tag identifying
protocols.
Example: Setting the default tag value for OSPF to introduce exterior routes to 20000.
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
412
Advertisement
Table of Contents
Troubleshooting
