Rip Configuration Commands - Accton Technology ES4626 Management Manual

ip rip receive version {1 | 2 | 1 2}
no ip rip receive version
ip rip receive version none
ip rip send version none
4. Disable RIP
Command
Global Mode
no router rip
RIP (Routing Information Protocol) is a dynamic interior routing protocol based on
distance vector. It is widely used for its simple configuration. RIP exchanges routing
information by UDP packet advertisement, route update information is sent every 30
seconds. It uses hop number to be the standard of choosing route, route of fewer hops to
the same destination network will be chosen first. The maximum hop number allowed is
16, so RIP is suitable for autonomous system with relative smaller diameter. RIP
configuration commands are mainly used in Global Mode, RIP configuration mode,
Interface Mode and Admin Mode.

15.3.2.2 RIP Configuration Commands

auto-summary
default-metric
ip rip authentication key
ip rip authentication mode
ip rip metricin
ip rip metricout
ip rip receive version
ip rip receive version none
ip rip send version
ip rip send version none
ip rip work
ip split horizon
redistribute
rip broadcast
rip checkzero
rip preference
Sets the version of RIP packets to receive on
all ports; the "no ip rip receive version"
command restores the default, i.e., receive
both v1 and v2 packets, enables receiving RIP
packets on the interface.
Disables receiving RIP packets on the
interface
Disables sending RIP packets on the interface
Explanation
Disables RIP
373