Switch (Ms2) For The Upper Cover; Adjusting The Height Of The Rdf - Oce 3121 Technical & Service Manual

2 Switch (MS2) for the upper cover

Check that both the switch for the front cover and the switch for the rear upper
1
cover are actuated: when the upper cover is closed.

3 Adjusting the height of the RDF

Remove the rear cover.
1
Close the RDF, and check that there is a 0.2 ±0.1 mm gap.
2
To adjust, loosen the nut and turn the bolt of the appropriate support.
3
After adjustment, tighten the nuts to lock.
4
*Approximately two sheets of paper (80 g/m2) may be inserted.
a
a
a=0.2 + 0.1 mm
a=0.2+0.1mm
Rear cover
Rear cover
(copier)
Also, at the front, check that both of the rubber feet are touching the platen
5
glass.
302 TSM Océ 3121
Support
Support
Bolt
Bolt
(copier)
RDF
RDF body
Rubber foot
Rubber foot
(rear)
(rear)
The rear doc-
Horizontal
ument guide
size plate
Nut
Nut
Platen
Copyboard glass
Rubber foot (front)
Rubber foot
(front)
Copier
Copier
Adjustments