Stopping Printing Operation; Cutting Media - Oce CS9360 User Manual

CS9360 User's Guide
NOTE
If a large amount of data is saved on the printer, the operation panel may not return to

Normal by a single [Cancel] operation.
In such cases, wait for a few seconds and press [Cancel] again.
4.3.3

Cutting media

If Media ejection mode is set to "Cut", the printer cuts the media automatically after printing.
5.1.6 Output Mode menu
If you press [Cutting] more than two seconds while the operation panel is Normal, you can cut the media
at the desired position.
Step 1: Confirm that the operation panel is Normal.
Step 2:
Press [Cutting] for more than two seconds.
The printer feeds the roll media to the length of the margin and cuts the media.

NOTE
When loading the new roll media, cut the front edge of the media if it is not straight.

The cutter is a consumable component. Replace it periodically.

6.1.4 Replacing Cutter
When the media detection is set to "Off", the media cannot be cut automatically.

4-87