Replacing The Cutting Blade - Oce CS9090 User Manual

Chapter 7: Maintenance

7.4.2 Replacing the cutting blade

Read following information on when and how to replace the cutting blade.
(1) Replacement time
Replace the cutting blade under the following conditions.
a. Media cannot be cut cleanly
The message "media Cut Error" appears on the operation panel if a media cutting error occurs.
b. When the cut edge has scuffing
(2) Replacement procedure
Follow the steps below to replace the cutting blade.
If the printer is turned on, make sure of the following
Step 1 :
Printing or other operations are not performed.
I)
II) Make sure that the display on the operation panel shows the normal status.
III) The MEDIA SET light on the operation panel goes off.
Follow "Menu setup on the operation panel" and display the cutting blade replacement menu on
Step 2 :
the operation panel.(Refer to 'Cutter change menu')
Select "Yes" by pressing the [F2] key on the operation panel.
Step 3 :
The printer prepares for cutting blade replacement.
I)
II) The carriage moves to the cutting blade replacement position.
III) The following message is displayed on the operation panel.
Notes
•
If you did one of the things mentioned in step 3, the printer does not replace the cutting blade and
returns to the setup menu.
•
Press the [CANCEL] key on the operation panel.
•
Select "NO" then press the [F1] key on the operation panel.
AP-75036 - Revision 1.3 – 20/03/06 162 User's Guide CS9000 series