NEC Univerge SV8100 Features And Specifications Manual page 1421

UNIVERGE SV8100
Program
Program Name
Number
13-04-04 Speed Dialing Number and Name
– Transfer Destination Number
13-04-05 Speed Dialing Number and Name
– Incoming Ring Pattern
14-01-04 Basic Trunk Data Setup –
Transmit Gain Level for
Conference and Transfer Calls
14-01-05 Basic Trunk Data Setup –
Receive Gain Level for
Conference and Transfer Calls
14-01-13 Basic Trunk Data Setup –
Trunk-to-Trunk Transfer
20-06-01 Class of Service for Extensions
20-07-05 Class of Service Options
(Administrator Level) – Set/
Cancel Automatic
Trunk-to-Trunk Transfer
Tandem Trunking (Unsupervised Conference)
Description/Comments
Store transfer destination number
data in the Speed Dialing areas.
Store incoming ring pattern data in
the Speed Dialing areas.
Select the Transmit CODEC gain
level used by the trunk when it is
part of an Unsupervised
Conference.
Select the Receive CODEC gain
level used by the trunk when it is
part of an Unsupervised
Conference.
For each trunk, enter 1 to enable
loop supervision.
Assign a Class of Service (1~15)
to an extension.
Turn Off or On an extension user
ability to use the Trunk-to-Trunk
Forwarding service codes.
Assigned Data
1
If Transfer mode is
(Refer to 13-04-03):
1 = Internal Dial Mode
#
1~9, 0, , , P, R, @

(Maximum 24
Characters)
2 = Incoming Ring
Group
0 ~ 100 (IRG Number)
P=Pause R=Recall
@= Additional Digits
when using ISDN
functionality
(default not assigned)
Incoming Ring Pattern
0 = Normal Pattern
1 ~ 4 = Tone Pattern
(1~4)
5 ~ 9 = Scale Pattern
(1~5)
(default = 0)
1~63(-15.5dB~
+15.5dB in 0.5dB
intervals)
[default = 32 (0dB)]
1~63(-15.5dB~
+15.5dB in 0.5dB
intervals)
[default = 16 (-8dB)]
0 = Disable

1 = Enable
(default = 1)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:

Extension port 101 =
Class 15
All other extension port
= Class 1
0 = Off
1 = On

(default = 0 for
COS 1~15)
Issue 7.0
Level
2 3




2 - 1393