NEC Univerge SV8100 Features And Specifications Manual page 1556

Issue 7.0
Program
Program Name
Number
14-02-14 Analog Trunk Data Setup – Loop
Start/Ground Start
14-05-01 Trunk Group – Trunk Group
Number
44-01-01 System Options for ARS/F-Route
– ARS/F-Route Time Schedule
44-02-01 Dial Analysis Table for ARS/
F-Route Access – Dial
44-02-02 Dial Analysis Table for ARS/
F-Route Access – Service Type
44-02-03 Dial Analysis Table for ARS/
F-Route Access – Additional
Data
44-02-04 Dial Analysis Table for ARS/
F-Route Access – Dial Tone
Simulation
2 - 1528
Description/Comments
Define an analog trunk as Loop
Start or Ground Start.
Assign trunks to trunk groups
(1~100).
Set this option to 0 so the F-Route
table selected is determined only
by the digits dialed without any
relation to the day or time of the
call. If 1 is selected, the system
refers to Program 44-10. If there
is a match, the pattern defined in
that program is used. If not, the
F-Route pattern in Program 44-09
and the time set in 44-08 are used.
Set the number of digits to be
analyzed by the system for ARS
routing.
Select the Service Type.
Enter the additional data required
for the service type selected in
Program 44-02-02, either the
number of digits to be deleted or
the table number to be used.
If Enabled (1), this option sends
dial tone to the calling party after
the routing is determined. This
may be required if the central
office at the destination does not
send dial tone.
UNIVERGE SV8100
Assigned Data
1
0 = Loop Start

1 = Ground Start
(default = 0)
Trunk Group Number:
0~100 Priority Number:

1~200 (default = Trunk
Group 1, with priority in
ascending order.)
0 = Not Used
1 = Used
(default = 0)
Up to eight digits
(Use line key 1 for a

'Don't Care digit, @)
(default not assigned)
0 = No Setting (None)
1 = Extension Call
(Own)
2 = ARS/F-Route Table

(F-Route)
3 = Dial Extension
Analyze Table (Option)
(default = 0)
1 = Delete Digit =
0~255 (255 : Delete All
Digits)
2 = 0~500
(0 = No Setting)

3 = Dial Extension
Analyze Table Number
= 0~4
(0 = No Setting)
(default = 0)
0 = Off
1 = On
(default = 0)
Uniform Numbering Network
Level
2 3

