NEC Univerge SV8100 Features And Specifications Manual page 1533

UNIVERGE SV8100
Program
Program Name
Number
84-26-01 IPL Basic Setup – IP Address
99-01-60 Options 60
uMC Server Configuration for SV8100
Parameter Name
In addition to the settings below you should create a pool of reserve users. There should be three reserve pool
users for every 10 uMobility users that are connected to your IP-PBX system. For example, if you have 25
uMobility users then you should create eight reserve pool users both in the IP-PBX and in uMobility. The exact
number of reserve pool users for your particular system depends on call profiles and feature usage.
These reserve pool users and used by the uMC server for certain call control functions and should all be included
in the hunt group defined in the SV8100 programming section. The number of Reserve Pool Users defined in
uMC Server configuration determines the maximum number of uMobility client devices that reside in the cellular
domain that can simultaneously make calls through the SV8100 system.
Registration_With_CM
UMC_IP
User Domain
Call Manager IP
Call Manager Port
CM_Side_Auth
Client_Side_Auth
Enforce_Dial_Plan
uMobility
Description/Comments
Assign the IP address for each
DSP on the IPLA.
This setting affects SIP messages
when using the Call Forward with
Both Ring feature. For the
uMobility and Desk phone to work
properly this must be set to 1 (On).
Required Data Assignment
ON
Set uMC Server IP Address.
Enter the SV8100 IP Address from Program 10-12-09 here.
Enter the SV8100 IP Address from Program 10-12-09 here.
Enter SV8100 SIP port from Program 84-20-01 here. Default is 5070.
If the uMC server port must enter a password to register with the
SV8100 set this field to on. Otherwise set to off.
If the uMobility client device must enter a password to register with the
SV8100 set this field to on. Otherwise set to off.
ON
This field is used to enable or disable the server from following the
Outgoing_Prefix and Handoff_Prefix fields. If this is set to off the client
devices will always have to dial a trunk access code. This means their
cell phone contact list numbers would need the trunk access code.
Assigned Data
1
xxx.xxx.xxx.xxx
Defaults:
Slot 1 = 172.16.0.20
:

Slot 4 = 172.16.0.44
VoIP GW 1~8:
172.16.0.20~
172.16.0.27
0 = Off
1 = On

(default = 0)
1







Issue 7.0
Level
2 3
Level
2 3


2 - 1505