NEC Univerge SV8100 Features And Specifications Manual page 1003

UNIVERGE SV8100
Program
Program Name
Number
81-11-08 Tie Line Initial Setup – Length of
Delay Signal Selection
81-11-09 Tie Line Initial Setup – Incoming
Interdigit Timeout Selection
81-11-10 Tie Line Initial Setup – Wink/
Delay Signal Detect Timeout
Selection
81-11-11 Tie Line Initial Setup –
Disconnect Recognition Time
Selection
81-11-12 Tie Line Initial Setup – Automatic
Release Signal Detection
Selection
81-11-13 Pause Time Selection
Operation
None
Multiple Trunk Types
Description/Comments
Specify the time a delay pulse is
sent to another system.
Specify the time that an address
signal is missing during the
incoming call detection process
before an error tone is returned to
the other system.
Specify a maximum time for
receiving an acknowledgment
signal from a distant system
before sending a busy tone.
Specify the minimum time before a
disconnected circuit can be
accessed again.
Specify the signal detection time
for release of a Tie Line after a
disconnect signal is received from
the distant Central Office or PBX.
Specify the length of a pause
(500~7500ms).
Assigned Data
1
1~15
(300 ms~4.5 seconds)
(0 = No Setting)
[default = 1 (300ms)]
0 = 8
1~15
(1~15 seconds)
(default = 6)
0 = 8
1~15
(1~15 seconds)
(default = 7)
1~15
(0.1~1.5 seconds)
(0 = No Setting)
[default = 3 (0.3
seconds)]
1~14
(50~700 ms)
15 = (No Limit)
(0 = No Setting)
[default = 7 (350ms)]
1~15 (500~7500ms
[default = 6 (3000ms)]
Issue 7.0
Level
2 3






2 - 975