NEC Univerge SV8100 Features And Specifications Manual page 1395

UNIVERGE SV8100
SMDR can print trunk port names or received dialed number for ANI/DNIS or DID trunks. If

enabled in programming, DNIS digits can be printed on the SMDR reports instead of the
trunk name.
T1 trunks follow Tie Line toll restriction programming (Program 34-01-05 and Program

34-08).
When using Fractional T-1s, the blade comes up with zero ports until Program 10-03-06 is

set to the 4/8/12/16/20/24(auto) and then reset.
If the number of ports are changed for a fractional T-1 in Program 10-03-06, the trunk ports

could be reassigned if the numerical sequence would split or it could fit into an empty gap of
trunk ports.
Examples:
The CD-4COTB with PZ-4COTF is assigned for trunk ports 1~8 and 17~24 and the T-1 (12
ports) was assigned as ports 25~36, the number of T-1s change to eight ports instead of
12. The new trunk port numbers are assigned as 9~16 because the eight ports can fit into
the gap between ports 8 and 17 without splitting the numerical port number sequence.
The CD-4COTB with PZ-4COTF is assigned for trunk ports 1~8 and 17~24 and the T-1
(eight ports) was assigned as 9~16 and then the T-1 was changed from eight to 12 ports.
The new trunk port numbers are assigned as 25~36 because the port number sequence
would have to be split to keep them within the original number sequence (9~16) and
splitting the numerical port number sequence is not supported.
Incoming calls on T1/ANI trunks can only follow Program 22-11-01. They do not follow

Programs 22-11-05 and 22-11-06.
Default Setting
Disabled
System Availability
Terminals
All Terminals
Required Component(s)
CD-PRTA
Locally provided CSU/DSU
T1 Trunking (with ANI/DNIS Compatibility)
Issue 7.0
2 - 1367