NEC Univerge SV8100 Features And Specifications Manual page 1845

UNIVERGE SV8100
To program a key, press Speaker, dial 751 (for 2-digit codes) or 752 (for 3-digit codes),
For this feature...
Headset
Operation
Hold
Meet Me
Conference
(Also see
Conference)
Memo Dial
Message Waiting
Microphone Cutoff
Call Arrival (CAR)
Keys
Name Storing
Features and Specifications Manual
Table 3-4 Function Key Codes by Feature (Continued)
press the key and enter the code (e.g., 48 for Voice Over).
Use this key...
Code: 05
Operation: Press key
Code: 44
Operation: Place or
answer call + Press
key
Code: 45
Operation: Place or
answer call + Press
key
Code: 32
Operation: Press key
Code: 31
Operation:
Store: While on call,
press key + number to
store
Use: Press Key + Call
or line
Erase: Speaker key +
Press key
Code: 38
Operation: Leave
message: Call ext +
Press key OR Answer
message: Press key
Code: 02
Operation: Set up call
+ Press key
Code: 03 + ext. or

dept group
Operation: Press key
Code: 55
Operation: Press key
+ ext ## + name + Hold
When you ...
Enable or disable
Headset Operation.
Put a call on System Hold
(if your telephone Hold
key is reassigned).
Put a call on Exclusive
Hold.
Join a Meet Me
Conference.
Store, use or check a
Memo dial number.
Answer/Leave a
Message Waiting.
Use Microphone Cutoff.
Place or answer a call to
your virtual (phantom)
extension.
Enter a name for the
extension to be displayed
on telephones.
Also See
Key Lamp Status
Srvc Code
On red when
activated
None
None
None 763 or 764
None
None
On red when
activated
Slow Flash red
when ringing, On
red when busy
None
Issue 7.0
688
-
-
-
0

-
-
700
3 - 31