NEC Univerge SV8100 Features And Specifications Manual page 1404

Issue 7.0
Program
Program Name
Number
34-09-06 ANI/DNIS Service Options –
Routing SPD Table Setup
34-09-07 ANI/DNIS Service Options –
Routing on ANI/DNIS Error
34-09-08 ANI/DNIS Service Options –
Routing When Destination Busy
or No Answer
34-09-09 ANI/DNIS Service Options –
Calling Number Address Length
34-10-01 Digits Delete for T1 ANI
Assignment
2 - 1376
Description/Comments
Define which part of the SPD Dial
Table set up in Program 13-04 the
system uses for ANI/DNIS Caller
ID look-ups and ANI/DNIS routing
(Start = 0, 100~1900, End = 0,
99~1999). This is required if Items
4 and 5 above are 1 (Caller ID on).
When you specify a starting and
end address, the system uses the
part of the table for look-ups.
When you specify a starting
address and length, the system
uses that part of the table for
routing. If the incoming ANI/DNIS
number data matches the Number
entry in the table, the system
routes according to the associated
Name data. That data can be an
extension, Department Group pilot
number, the voice mail master
number or a trunk ring group.
Determine how the system
handles an ANI/DNIS call if a data
error is detected in the incoming
data string.
Determine how the system
handles an ANI/DNIS call if
destination is busy or does not
answer.
When Item 01 = 0 (ANI/DNIS
receive format is address), specify
the address length. The choices
are 1~8 digits.
Define the number of digits to
delete from the information
element received from Telco.
T1 Trunking (with ANI/DNIS Compatibility)
UNIVERGE SV8100
Assigned Data
1
Start=0, 100~1900
End= 0, 99~1999
Default:
COS 1~15
Start = 0
End = 0
0 = Play Busy Tone to
Caller
1 = Route Caller to
Ring Group Specified
in Program 25-03
(Transfer)
(default = 0 for
COS 1~15
0 = Play Busy or
Ringback Tone to
Caller (Busy/ NoAns)
1 = Route Caller to
Ring Group Specified
in Program 25-04
(Transfer)
(default = 0 for
COS 1~15)
1~8
(default = 7 for
COS 1~15)
0~9
(default = 2)
Level
2 3




