NEC Univerge SV8100 Features And Specifications Manual page 994

Issue 7.0
Program
Program Name
Number
22-02-01 Incoming Call Trunk Setup
34-01-01 E&M Tie Line Basic Setup – DID/
E&M Start Signaling
34-01-03 E&M Tie Line Basic Setup – E&M
Dial-In Mode
34-01-04 E&M Tie Line Basic Setup – E&M
Line Dial Tone
34-01-05 E&M Tie Line Basic Setup –
System Toll Restriction
34-02-01 E&M Tie Line Class of Service
34-03-01 Trunk Group Routing for E&M
Tie Lines
2 - 966
Description/Comments
Set the feature type for the trunk
you are programming. For each
Night Service mode, enter 5 when
the trunk should be an E&M tie
line.
Set the start signaling mode for
DID and Tie trunks. They can use
either immediate start or Wink
start signaling.
Determine if the incoming Tie Line
call should be directed as an
intercom call or if it should follow
the DID Translation Table in
Program 22-11-01.
Enable if the Tie Line should send
dial tone to the calling system after
the call is set up. Disable if the Tie
Line should not send dial tone.
Determine if an incoming Tie Line
call should be subject to Toll
Restriction.
Assign the Tie Line Class of
Service (1~15). Use Program
20-14-01 to set the Tie Line Class
of Service options. You cannot
use Program 20-06 to assign
Class of Service to Tie Lines.
Assign the trunk group route
chosen when a user seizes a Tie
Line and dials 9. Set Trunk Group
Routing in Program 14-06-01. If
the system has ARS, dial 9 to
access ARS.
UNIVERGE SV8100
Assigned Data
1
0 = Normal
1 = VRS (second dial
tone if no VRS
installed)
2 = DISA
3 = DID

4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
0 = 2nd Dial Tone
1 = Wink (default)
2 = Immediate
3 = Delay
(default = 1)
0 = Specify Extension
Number (Intercom)
1 = Use Conversion
Table (NTT)
(default = 0)
0 = Disable (No)
1 = Enable (Yes)
(default = 1)
0 = No (Off)
1 = Yes (On)
(default = 0)
Day/Night Mode
1~8
Class: 1~15
(default = 1)
0~100
(0 = No Setting)
(default = 1)
Multiple Trunk Types
Level
2 3





