NEC Univerge SV8100 Features And Specifications Manual page 1652

Hide thumbs Also See for Univerge SV8100:

Table of Contents

System software Version 4000 or higher is required to support this feature.

The InMail language prompts installed on the CF must be Version 2.10 or higher. The

VM8000 InMail Utility is used to update the installed language prompts.

If the InMail CF has Version 2.00 instead of Version 2.10 prompt sets installed, only a

single destination Message Notification is available using Notification Schedule entry 1.

Retry Interval timers are set on a system wide basis only.

The pager dial string is set on a system wide basis only.

Notification settings can be changed using the Telephone Mailbox Option Interface or

system programming only.

When the retries for a particular destination have been met the system will immediately

move to the next destination even if there is only one destination active.

Once the notification process begins, a new message does not restart the process if it is

already in progress. Once the process ends (e.g., if the message is acknowledged or the

maximum number of callout attempts is reached), the next new message will restart the

The system determines which numbers are internal extensions or external numbers by the

system dial plan settings.

Depending on the system ARS routing maybe needed to properly route external calls.

If no trunks are available when an outside destination is attempted it is counted as a Busy

No Answer attempt.

VM8000 InMail – Cascade Message Notification

UNIVERGE SV8100