NEC Univerge SV8100 Features And Specifications Manual page 964

Issue 7.0
Related Features
Handsfree Answerback/Forced Intercom Ringing
Handset Mute
Programmable Function Keys
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
15-07-01 Programmable Function Keys
20-02-11 System Options for Multiline
Telephones – Handsfree
Microphone Control
2 - 936
Description/Comments
If an extension needs handset
microphone cutoff, program a
Handset Transmission Cutoff key
(code 40). To program a MIC
Cutoff key, use code 02 as the
entry. The MIC Cutoff key mutes
conversation on a handsfree call,
but the Handset Transmission
Cutoff key mutes the handset
transmission on a non-handsfree
call.
Control the setting for multiline
terminal handsfree microphone
after being disconnected and
reconnected. If set to 0, the
microphone is always off when the
terminal is reconnected. If set to
1, the microphone remains in the
same state it was in when the
terminal is reconnected.
UNIVERGE SV8100
Assigned Data
1
For Line Keys: 1~48
0 ~ 99 (Normal
Function Code)
(default = Service
Code 751)*

 
00 ~ 99
(Appearance Function
Code) (default =
Service Code 752)
0 = Off
1 = On
(default = 1
Microphone Cutoff
Level
2 3
