NEC Univerge SV8100 Features And Specifications Manual page 1171

UNIVERGE SV8100
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
11-04-01 Virtual Extension Numbering
15-01-01 Basic Extension Data Setup –
Extension Name
15-02-07 Multiline Telephone Basic Data
Setup – Automatic Hold for CO
lines
15-02-21 Multiline Telephone Basic Data
Setup – Virtual Extension
Access Mode (When idle Virtual
Extension key pressed)
Secondary Incoming Extension
Description/Comments
Assign virtual extension numbers.
Define the extension/virtual
extension name.
When talking on a CO call and
another CO line key is pressed,
place the original trunk on Hold or
Disconnect it.
Determine whether a Virtual
Extension/Call Arrival Key (CAR)
should function as a DSS key, a
Virtual Extension, or a CAR key.
When DSS (0) is selected, the key
functions as a DSS key to the
extension and for incoming calls to
that extension. When Outgoing (1)
is selected, the key functions as a
virtual extension and can be used
for incoming and outgoing calls.
When Ignore (2) is selected, the
key functions as a CAR key and
can receive incoming calls only.
Assigned Data
1
Up to eight digits
1 201
2 202
3 203
~ ~
99 299
100 3601
~ ~
256 3857
Up to 12 characters
Default:
STA 101 = Ext 101
STA 102 = Ext 102,
etc.
0 = Hold
1 = Disconnect (Cut)
(default = 1)
Virtual Extension Key
Mode
0 = DSS
1 = OTG (Outgoing)
2 = Ignore
(default = 2)
Issue 7.0
Level
2 3




2 - 1143