NEC Univerge SV8100 Features And Specifications Manual page 1401

UNIVERGE SV8100
Program
Program Name
Number
20-14-07 Class of Service Options for
DISA/E&M – External Paging
20-14-08 Class of Service Options for
DISA/E&M – Direct Trunk Access
20-14-09 Class of Service Options for
DISA/E&M – Forced Trunk
Disconnect <Not for ISDN
T-point>
20-14-10 Class of Service Options for
DISA/E&M – Call Forward Setting
by Remote via DISA
20-14-11 Class of Service Options for
DISA/E&M – DISA/Tie Trunk
Barge-In
20-14-12 Class of Service Options for
DISA/E&M – Retrieve Park Hold
22-02-01 Incoming Call Trunk Setup –
Incoming Type
22-11-01 DID Translation Number
Conversion – Received Number
22-11-02 DID Translation Number
Conversion – Target Number
T1 Trunking (with ANI/DNIS Compatibility)
Description/Comments
Enable/Disable a DISA or tie trunk
caller ability to use telephone
system External Paging.
Enable/Disable a DISA or tie trunk
caller ability to use Direct Trunk
Access (Service Code 715).
Enable/Disable a tie trunk caller
ability to use Forced Trunk
Disconnect (Service Code 26).
This option is not available to
DISA callers.
Enable/Disable a DISA caller
ability to use the Call Forward
service codes (Program 11-11-01
through Program 11-11-05).
Enable/Disable a DISA or tie trunk
user from using the Barge-In
feature.
Turn Off or On the ability for a
DISA caller to retrieve parked or
held calls.
For each T1 trunk, set the Trunk
Service Type to match the Telco
connected T1 service. For each
T1 trunk that should support ANI/
DNIS service, enter 7. (ANI/DNIS
trunks must be immediate start or
wink start T1 trunks with E&M
signaling.) For T1 loop/ground
start trunks defined as 0, Program
14-02-02 must be set to 1 for the
trunks to ring and light correctly.
For each DID Translation Table
entry (1~2000), specify the digits
received by the system.
For each DID Translation Table
entry (1~2000), specify the
extension the system dials after
translation.
Assigned Data
1
0 = Off
1 = On
(default = 1 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Off
1 = On
(default = 1 for
COS 1~15)
0 = Normal
1 = VRS (second dial
tone if no VRS
installed)
2 = DISA
3 = DID

4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
Maximum eight digits

(default not assigned)
Maximum 24 digits
(default not assigned)

Issue 7.0
Level
2 3






2 - 1373