NEC Univerge SV8100 Features And Specifications Manual page 1420

Issue 7.0
Method D – Tandem Trunking to Speed Dial Number
Program
Program Name
Number
11-10-06 Service Code Setup (for System
Administrator) – Setting the
Automatic Transfer for Each
Trunk Line
11-10-07 Service Code Setup (for System
Administrator) – Canceling the
Automatic Transfer for Each
Trunk Line
11-10-08 Service Code Setup (for System
Administrator) – Setting the
Destination for Automatic Trunk
Transfer
13-04-01 Speed Dialing Number and Name
– Speed Dialing Data
13-04-02 Speed Dialing Number and Name
– Name
13-04-03 Speed Dialing Number and Name
– Transfer Mode
2 - 1392
Description/Comments
If the default service code (733) for
enabling Automatic Tandem
Trunking feature is not acceptable,
change the code as required.
If the default service code (734) for
canceling Automatic Tandem
Trunking feature is not acceptable,
change the code as required.
If the default service code (735) for
setting the destination of the
Automatic Tandem Trunking
feature is not acceptable, change
the code as required.
Enter the number and name for
the bins used to hold the
Automatic Tandem Trunking
destination.
Assign a name to each System
Speed Dial bin.
Assign the transfer mode for each
System Speed Dial bin.
Tandem Trunking (Unsupervised Conference)
UNIVERGE SV8100
Assigned Data
1
MLT
(default = 733)
MLT
(default = 734)
MLT
(default = 735)
#
1~9, 0, ,
Pause (Press line key
1)
Recall/Flash (Press
line key 2)

@ = Code to wait for
answer supervision in
ISDN (Press line key 3)
(maximum 24 digits)
(default not assigned)
Maximum 12
Characters
(Use dial pad to enter
name)
(default not assigned)
0 = Not Used
1 = Internal Dial
2 = Incoming Ring
Group (IRG)
(default = 0)
Level
2 3




